Press F6 when you see the following prompt at the bottom of the screen during the Windows Setup process: Connect the floppy drive to the JavaRConsole system if necessary and insert the mass-storage drivers floppy disk into the floppy drive. Follow these steps to install the Microsoft Windows Server software onto your server. Press any key to restart. If you are using a Windows Server media CD created using the Sun reburn script, do the following: Note – The complete Microsoft Windows operating system installation process is not documented in this section.
|Date Added:||7 June 2016|
|File Size:||52.94 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Adaptec – Adaptec RAID
Ensure that the floppy. If you created a RAID volume on your boot disk as part of your prerequisite preparations for installing Windows, press C to select Custom Setup and manually partition the sevice. If you are using a Windows Server media CD created using the Sun reburn script, do the following: When this message appears you will need to complete one of the following steps, depending on which driver delivery method you have chosen, to complete the installation:. This chapter describes how to aadptec the Windows Server operating system directly onto your server using the Windows Server media.
Windowa Enter to continue. Make sure that the mass storage drivers are accessible according to the mass storage driver installation method that you have selected. Note – The prompt is displayed in the early stages of Windows Setup and lasts for approximately five seconds and is easy to miss.
Before beginning adaptdc operating system installation, make sure that the following requirements are met. You will need to restart the system and go back to Step 3.
Make sure to reserve a minimum of MB of unpartitioned devicee at the end of the drive. Select a setup mode Express or Custom and continue. This section documents only the steps that are specific for installing Windows Server on your server. Note – The complete Microsoft Windows operating system installation process is not documented in this section. The required mass storage drivers have been copied to the Windows media CD by the reburn script sindows will be identified and installed for you during the installation process.
The Windows installation will format the boot disk and all data will be lost. To Install the Operating System.
DriverZone.com: The place to find device driver updates.
Connect the floppy drive to the JavaRConsole system if necessary and insert the mass-storage drivers floppy disk into the floppy drive. Follow the on-screen instructions to complete the initial setup of Windows Server until you are prompted with the following message:.
If you do not press F6 while the prompt is being revice, the screen allowing you to specify additional 203 is not displayed and the installation will fail. Press any key to restart.
Otherwise, press Enter to select Express Setup. Follow these steps to install the Microsoft Windows Server software onto your server. Press S to specify additional devices. For requirements specific to the mass storage driver and Windows media delivery methods that you have chosen, see TABLE Follow the Windows setup was instructions to install the operating system.
Windows Setup lists the driver to be installed. Select the appropriate mass storage controller driver version depending on the version of Windows bit or bit you are installing, and then press Enter:.
Press F6 when you see the following prompt at the bottom of the screen during the Windows Setup process: If prompted with Press any key to boot from CDquickly press any key.
Install Windows Server Remove disks or other media. Note that if you are using the floppy disk local installation method, the JavaRConsole floppy drive or floppy image devices must not be redirected. Then, press any key rid restart the system and complete the Windows Server Installation. After pressing F6, a screen will appear providing you with the rqid to specify additional mass storage devices.
Make sure that you have completed all of the requirements listed in Installation Requirements. At the Welcome to Setup screen, press Enter to continue.